Oki ML6300FB-SC User Manual

Operating instructions > 33
I NITIALISING MENU SETTINGS
To restore the menu settings to their initial values, carry out the steps below.
1. Set the Power Switch to OFF.
2. Press and hold down the SEL and SHIFT buttons together then set the Power Switch
to ON.
A DJUSTING TOF POSITION
Use the following procedure to set TOF to accord with the reference position (6.35 mm
(0.25 in)). The reference position refers to the first line of the paper i.e. the position to
which the printer feeds the paper when automatically loading the paper.
1. Print out the menu settings of the printer as in “Confirming current settings” on
page 26 and confirm that the TOF (in cut sheet mode or continuous forms mode) is
6.35 mm (0.25 in).
2. Set the Paper Type lever to the required paper type.
3. When continuous forms are used, place the paper on the Pin Tractor.
For cut sheet mode, do not insert the paper at this stage.
4. In continuous forms mode, press the FF/LOAD button.
In cut sheet manual feeding mode, press the FF/LOAD button and place the paper on
the Paper Tray.
The paper is taken into the default 6.35 mm (0.25 in) position.
5. Align the paper with the first print line position as follows:
In off-line mode, press the following buttons to adjust the first printing line:
To feed the paper forward by a small amount, hold down the SHIFT button and press
the FF/LOAD button.
To feed the paper backward by a small amount, hold down the SHIFT button and
press the LF button.
6. When the paper is positioned at the required TOF, release the buttons in Step 5
above.
To save this position as the TOF, ensure the printer is off-line and press and hold
down the SHIFT and PARK buttons for 3 seconds.
NOTE
The values adjusted by the Adjustment menus are not initialised by the
following procedure.
NOTE
Adjusting of TOF can be done in cut sheet mode or continuous forms mode.
NOTE
The correction range is between 2.12 mm (top of the paper) to 368.3 mm. If
the specified correction is beyond this range, the settings will not be
recognised by the printer.
NOTE
Do not turn the Platen Knob or switch off the printer during the above
procedure.

Oki ML6300FB-SC Specifications

General

Color	No
Character pitch	10, 12, 15, 17, 17.1, 20 cpi
Maximum resolution	360 x 360 DPI
Maximum printing width (columns)	-
Fonts included	Courier, Roman, Swiss, Prestige, Gothic, Utility, Swiss Bold, Orator, OCR-A, OCR-B, HSD & Barcodes
Print technology	Dot matrix
Connectivity technology	Wired
Page description languages	Epson ESC/P2, IBM ProPrinter
Sound pressure level (printing)	58 dB
Print direction	Bi-directional
Mean time between failures (MTBF)	12000 h
Paper feed	Manual
Standard interfaces	Parallel, USB 2.0
Optional connectivity	Ethernet, Serial (RS-232)
Windows operating systems supported	Yes
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	5 - 40 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	30 - 85 %
AC input voltage	220-240 V
AC input frequency	50 - 60 Hz

Weight and Dimensions

Depth	255 mm
Width	425 mm
Height	210 mm