4345-E P-10
SECTION 2 MacMan MAIN SCREEN
• If the reason for not-operating status is "PART WAITING", "MAINTENANCE", or "OTHER",
the automatic change function is not valid. If the machine has to be stopped, due to any of
these reasons, change the reason manually. When the machine restarts, change the rea-
son for not-operating status manually again.
The initial parameters are so set that the NC does not automatically change the reason for
not-operating status. To make the NC change the reason automatically, select MacMan
PARAMETER in the parameter setting mode and set the required data at the following
parameters:
• USE NOT OPERATING ITEM FOR AUTO DECISION (0=NO,1=YES)
0 (No)
• TIME ALLOWED BEFORE DETERMINING NO OPERATOR PRESENT (hh:mm:ss)
00:20:00 (20 minutes)
To Next Page
Loading...