4345-E P-12
SECTION 3 REPORT INFORMATION DISPLAY
• CUTTING
Length of time for which an axis has been moved at a cutting feedrate [hours:minutes:seconds]
Length of time an axis has been moves at a cutting feedrate in the machine lock mode or dry
run mode (NC lathe) is not counted.
• CYCLE TIME
Length of time for which power has been ON for producing one piece of workpiece [hours:min-
utes:seconds/pc.]
(Cycle time = Power on time (RUNNING) / No. of workpieces (NO. OF WORK))
• MACHINING
Length of operating time used for producing one piece of workpiece [hours:minutes:seconds/
pc.]
(Machining time = Operating time (RUNNING) / No. of workpieces (NO. OF WORK))
Operating Report
The report shows the operating status of the machine.
Machine operating report:
• RUNNING
Length of time for which power supply to the NC has been ON [hours:minutes:seconds]
(Power ON (RUNNING) = OPERATING + NOT OPERATNG)
• OPERATING
Length of time for which a main program has been executed
Length of time the main program has been executed in the machine lock mode or dry run mode
(NC lathe) is not counted.
(OPERATING = CUTTING + Not cutting)
• CUTTING
Length of time for which an axis has been moved at a cutting feedrate [hours:minutes:seconds]
Length of time an axis has been moved at a cutting feedrate in the machine lock mode or dry
run mode (NC lathe) is not counted.
• NOT OPERATNG
Length of time for which a main program has not been executed
(NOT OPERATING = IN-PRO SETUP + NO OPERATOR + PART WAITING + MAINTENANCE
+ OTHER)
• IN-PRO SETUP
Constituent of not-operating time: machine has not been operating due to in-process setup.
• NO OPERATOR
Constituent of not-operating time: machine has not been operating due to no operator atten-
dance.
• PART WAITING
Constituent of not-operating time: machine has not been operating due to waiting for workpiece
to be machined.
• MAINTENANCE
Constituent of not-operating time: machine has not been operating due to machine mainte-
nance.
• OTHER
Constituent of not-operating time: machine has not been operating due to reasons not classified
into the items indicated above.
• SPINDLE RUN
Length of time for which the spindle has been rotating
Length of time the spindle has been rotating in the machine lock mode is not counted.
To Next Page
Loading...