Turn and Lane Change Signals
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow
you to signal a turn or a lane change.
To
signal a turn, move the lever all the way up or
down. When the turn is finished, the lever will
return automatically.
I
1
An arrow on the instrument
panel will flash in the
direction of the turn or
lane change.
To
signal a lane change, just raise or lower the lever
until the arrow starts to flash.
Hold
it there until you
complete your lane changp The lever will return
bv
itself when you release it.
As you signal
a
turn or a lane change, if the arrows
don’t flash but just stay on, a signal bulb may be burned
out and other drivers won’t see your turn signal.
If a bulb
is
burned out, replace it
to
help avoid
an accident.
If the arrows don’t
go
on
at all when you signal a
turn,
check the fuse (see “Fuses and Circuit Breakers” in the
Index) and for burned-out bulbs.
Turn
Signal
On Chime
If your turn signal is left on for more than
3/4
of a mile
(1.2 km),
a
chime will sound and the DIC will display
the TURN SIGNAL ON? reminder message.
To
turn
off the chime, move the turn signal lever to the
off
position.
To
turn off the DIC message, press any button
on the DIC.
To Next Page
Loading...
Need help?
General
