Headlamp High/Low Beam Changer
To change the headlamps
from low beam to high or
high to low, pull the turn
signal lever all
the
way
toward you. Then release
it.
When the high beams are on, a light on the instrument
panel also will be on.
Flash-To-Pass
This feature lets you use your high-beam headlamps
to signal a driver in front of you that you want to pass.
It
works even if your headlamps are off.
To
use it, pull the turn signal lever toward you.
If your headlamps are off, your high-beam headlamps
will turn on. They’ll stay on as long as you hold the
lever there. Release the lever to turn them off.
If your headlamps are on, but on low beam, the system
works normally. Just pull the lever until it clicks. Your
headlamps will shift
to
high beam and stay there.
To
return to low beam, just pull the lever toward you.
If your headlamps are
on,
and
on
high beam, your
headlamps will switch
to
low beam.
To
get back to high
beam, pull the lever toward you.
To Next Page
Loading...
Need help?
General
