Playing
a Cassette
Tape
Your tape player
is
built to work best with tapes that are
30
to
45
minutes long on each side. Tapes longer than
that
are
so
thin they may not work well in this player.
The longer side with the tape visible should face to the
right.
If
the ignition
is
on, but the radio is off, the tape
can be inserted and will begin playing.
If
you hear
nothing but a garbled sound, the tape may not be in
squarely. Press EJECT to remove the tape and start over.
While the tape is playing, use the
VOL,
FADE,
BAL,
TREB, BASS, TONE, SEEK and SCAN controls just as
you
do
for the radio. (The
TONE
control is not available
on the Bose radio.) The display will show TP with a box
around it and an arrow to show which side of the tape
is playing.
Your tape bias is set automatically. When a metal or
chrome tape is inserted,
HI-BIAS
appears on the
display. If you want to insert a tape when the ignition is
off,
first press EJECT or RCL.
If
E
and a number appear on the radio display and the
tape won’t play because of an error, it could be that:
E10:
The tape is tight and the player can’t turn the
tape hubs. Remove the tape. Hold the tape with the
open end down and try to turn the right hub to the
left with a pencil. Turn the tape over and repeat. If
the hubs do not turn easily, your tape may be
damaged and should not be used in the player.
Try a new tape to make sure your player is
working properly.
Ell:
The tape is broken. Try a new tape.
If any error occurs repeatedly or if an error can’t be
corrected, please contact your retailer.
If
your radio
displays an error number,
write
it down and provide it to
your retailer when reporting the problem.
REV
(1):
Press this button to reverse the tape rapidly.
Press
it
again to return
to
playing speed. The radio will
play the last-selected station while the tape reverses.
You
may select stations during REV operation by
using
TUNE.
3-14
To Next Page
Loading...
Need help?
General
