Starting
Your
4.0L
Engine
1.
Without pushing the accelerator pedal, turn your
ignition key to START. When the engine starts, let
go of the key. The idle speed will go down as
your
engine gets warm.
I
1
I
NOTICE:
Holding your key in START for longer than
15
seconds at
a
time will cause your battery to
be drained much sooner. And the excessive heat
can damage
your
starter motor.
I
2.
If
it doesn’t start right away, hold your key in
START for about three seconds at a time until your
engine starts. Wait about
15
seconds between each
try to help avoid draining your battery or damaging
your starter.
3.
If
your engine still won’t start
(or
starts but then
stops), it could be flooded with too much gasoline.
Try pushing your accelerator pedal all the way to the
floor and holding it there as you hold the key in
START for about three seconds.
If
the vehicle starts
briefly but then stops again,
do
the same thing.
NOTICE:
Your engine is designed to work with the
electronics in your vehicle.
If
you add electrical
parts or accessories,
you
could change the
way
the engine operates, Before adding electrical
equipment, check with
your
retailer.
If
you don’t,
your engine might not perform properly.
If
you
ever have to have your vehicle towed, see
the part of this manual that tells how to do it
without damaging your vehicle. See “Towing
Your Vehicle”
in
the Index.
2-22