EasyManua.ls Logo

Oleo-Mac GS 35C - User Manual

Oleo-Mac GS 35C
60 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
GS 35C (38.9 cm
3
)
Euro 1*
- GS 350C (38.9 cm
3
)
Euro 2
*
I-Modello non disponibile per i mercati UE
GB - Model not available for EU markets
F-Modèle non disponible pour les pays UE
D-Modell nicht für EU-Markt verfügbar
E-Modelo no disponible para los mercados UE
SK - Model nie je k dispozícii pre trhy EÚ
I
D
F
GB
E
SK
OWNER’S MANUAL
MANUALE USO E MANUTENZIONE
BETRIEBS- UND WARTUNGSANLEITUNG
MANUEL D’UTILISATION ET D’ENTRETIEN
MANUAL DE USO Y MANTENIMIENTO
NÁVOD NA POUŽITIE A ÚDRŽBU
Pubbl. 50240221A - Ago/2016

Table of Contents

Other manuals for Oleo-Mac GS 35C

Preview: Product Information
Product Information7 pages

Questions and Answers

  • X
    Xavier ColemanAug 9, 2025
    How to fix Oleo-Mac GS 35C Chainsaw engine that will not start?
    • K
      Kyle NicholsAug 9, 2025
      If your Oleo-Mac Chainsaw engine will not start or runs only briefly after starting, ensure the ignition switch is in the start position “I”. The problem may be due to: 1. No spark. Check for a spark at the spark plug tip. If there's no spark, try again with a new spark plug (L6RTC). 2. Flooded engine. Follow the procedure on page 20. If it still fails, repeat with a new spark plug.
  • J
    jenniferlewisAug 14, 2025
    What to do if Oleo-Mac GS 35C Chainsaw engine starts and runs, but the chain is not rotating?
    • C
      Charles BuckAug 15, 2025
      If your Oleo-Mac chainsaw engine starts and runs, but the chain isn't rotating, consider these potential issues: * The chain brake might be engaged. Release the chain brake, referring to the OperationChain Brake Section (Pag.26). * The chain tension could be too tight. Adjust the chain tension as per the instructions in the Operation-Chain Tension section (Pag.12). * Refer to Assembly-Assembling the Bar and Chain Section (Pag.12). * Refer to Maintenance-Chain and/or Maintenance-Guide Bar Section (Pag.34). * If necessary, replace the component, contacting a Servicing Dealer.
  • M
    Mike GibbsAug 19, 2025
    Why is my Oleo-Mac GS 35C bar and chain running hot and smoking?
    • F
      Francis HowardAug 19, 2025
      Your Oleo-Mac Chainsaw bar and chain might be running hot and smoking due to several reasons: * The chain oil tank may be empty; it should be filled every time the fuel tank is filled. * The chain tension may be too tight; adjust the chain tension according to the instructions. * There may be an oiler malfunction. Run the chainsaw at full throttle for 15 to 30 seconds, then stop it and check for oil dripping from the bar tip guard and guide bar. If there's no oil, contact a servicing dealer.
  • C
    Cynthia QuinnAug 25, 2025
    What to do if Oleo-Mac GS 35C engine does not reach full speed and emits excessive smoke?
    • T
      Travis MurrayAug 25, 2025
      If your Oleo-Mac chainsaw engine isn't reaching full speed and is emitting excessive smoke, here's what you can do: 1. Check the oil fuel mixture. Use fresh fuel and the correct 2-cycle oil mix. 2. Inspect the air filter. If it's dirty, clean it following the instructions in the Maintenance-Air Filter Section. 3. The carburetor may need adjustment, in which case you should contact a Servicing Dealer.
  • J
    Joseph RossAug 29, 2025
    What to do if Oleo-Mac Chainsaw engine starts but will not accelerate properly?
    • J
      James SmithAug 29, 2025
      If your Oleo-Mac chainsaw engine starts but won't accelerate properly or run well at high speed, the carburetor likely requires adjustment. Contact a Servicing Dealer for carburetor adjustment.
  • K
    Katherine GarciaSep 3, 2025
    What to do if Oleo-Mac GS 35C engine starts, runs and accelerates but will not idle?
    • J
      Justin HartSep 4, 2025
      If your Oleo-Mac Chainsaw engine starts, runs, and accelerates but won't idle, turn the idle speed screw “T” clockwise to increase the idle speed. Refer to the Operation-Carburetor Adjustment section for more details.

Oleo-Mac GS 35C Specifications

General IconGeneral
Oil PumpAutomatic
Power Output1.5 kW
Bar Length35 cm
Fuel Tank Capacity0.35 L
ChainOregon
Chain Pitch3/8"
Chain Gauge1.3 mm (0.05 inches)

Related product manuals