EasyManua.ls Logo

Olimpia splendid SHERPA S2 E 12 - User Manual

Olimpia splendid SHERPA S2 E 12
101 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
SHERPA S2 E 12
SHERPA SE 2 12T
SHERPA S2 E 14
SHERPA S2 E 14T
SHERPA S2 E 16
SHERPA S2 E 16T
UNITÀ ESTERNA
MANUALE UTENTE E DI INSTALLAZIONE
Grazie per avere acquistato il nostro prodotto.
Prima di utilizzare l'unità, leggere attentamente il presente manuale e conservarlo
per poterlo consultare in futuro.

Table of Contents

Questions and Answers

  • L
    Lacey GlennAug 5, 2025
    Why is my Olimpia Splendid Heat Pump not cooling properly?
    • M
      Michelle BallardAug 5, 2025
      If your Olimpia Splendid Heat Pump isn't cooling well, several factors could be responsible. The outdoor and indoor unit heat exchangers or the water filter might be dirty, or the inlet/outlet of the units could be blocked. Direct sunlight or too much heat in the room can also reduce cooling efficiency. High outdoor temperatures or refrigerant leakage could also be the cause. You can clean the heat exchanger and water filter, clear any blockages, use curtains to block sunlight, and reduce heat sources. Also, have a technician check for refrigerant leaks and recharge the system as needed.
  • M
    meganmartinezAug 11, 2025
    What to do if my Olimpia splendid SHERPA S2 E 12 Heat Pump does not start?
    • M
      Michael ColeAug 11, 2025
      If your Olimpia Splendid Heat Pump unit doesn't start, it could be due to a power failure, the power switch being off, a blown fuse, or dead batteries in the remote controller. Wait for the power to come back on, switch on the power, replace the fuse, or replace the batteries in the remote controller. Also, check the controller for any other issues.
  • R
    Randy BradyAug 17, 2025
    Why is the heating effect low on my Olimpia Splendid Heat Pump?
    • J
      Julie SilvaAug 17, 2025
      Your Olimpia Splendid Heat Pump might have a low heating effect if the outdoor temperature is below 7°C or if there's a refrigerant leak. Consider using an additional heating device when the outdoor temperature is very low. Also, have a technician check for refrigerant leaks and recharge the system as needed.
  • D
    Desiree RamirezAug 22, 2025
    What to do if my Olimpia Splendid Heat Pump has airflow but isn't cooling?
    • E
      enielsenAug 22, 2025
      If your Olimpia Splendid Heat Pump is running, but not cooling the air, it might be due to an incorrect temperature setting or the compressor being in a 3-minute protection mode. Ensure the temperature is set correctly. If that's not the issue, simply wait, as the compressor may be in a protection mode.
  • A
    Anthony ReynoldsAug 29, 2025
    Why does my Olimpia splendid SHERPA S2 E 12 start and stop frequently?
    • K
      Kristina MccormickAug 29, 2025
      If your Olimpia Splendid Heat Pump starts and stops frequently, it could be caused by several issues: too little or too much refrigerant, air or non-condensing gas in the refrigerating circuit, a malfunctioning compressor, voltage issues, or a blocked system circuit. You should check for refrigerant leakage and recharge accordingly, vacuum and recharge the refrigerant, consider maintenance or replacement of the compressor, and install a manostat. You will need to investigate to find the exact cause and solution.

Summary

1 PRECAUTIONS

2 ACCESSORY AND REFRIGERANT

3 BEFORE INSTALLATION

Handling the Unit

Guidelines for safely moving and handling the outdoor unit.

4 IMPORTANT INFORMATION REGARDING THE REFRIGERANT USED

5 SELECTING INSTALLATION SITE

6 OUTDOOR UNIT INSTALLATION

6.1 Installation Place

Recommended and prohibited locations for outdoor unit installation.

6.2 Installation Space

Required clearances and dimensions for outdoor unit installation.

6.3 Moving and Installation

Instructions for lifting, positioning, and securing the outdoor unit.

6.4 Water Outlet

Details on the condensed water outlets and their usage.

7 INSTALL THE CONNECTING PIPE

7.1 Refrigerant Piping

Requirements and considerations for refrigerant pipe installation.

7.2 Leakage Detection

Methods for checking refrigerant pipe joints for leaks.

7.3 Heat Insulation

Instructions for insulating refrigerant pipes to prevent condensation.

7.4 Connecting Method

Procedure for connecting the refrigerant pipes and wiring.

7.5 Remove Dirt or Water in the Pipes

Steps to ensure pipes are clean before connecting.

7.6 Airtight Test

Procedure for testing the system's airtightness using nitrogen.

7.7 Air Purge with Vacuum Pump

Process for removing air from the refrigerant circuit using a vacuum pump.

7.8 Refrigerant Amount to be Added

Calculating and adding refrigerant based on pipe length.

8 ELECTRICAL WIRING

8.1 Outdoor Unit Wiring

Specifications and procedures for wiring the outdoor unit.

9 TEST RUNNING

10 PRECAUTIONS ON REFRIGERANT LEAKAGE

11 TURN OVER TO CUSTOMER

12 OPERATION AND PERFORMANCE

12.1 Protection Equipment

Explanation of the unit's protection features and operating conditions.

12.2 About Power Cut

Procedure for handling power interruptions during operation.

12.3 Heating Capacity

Factors affecting heating capacity and performance.

13 MALFUNCTION CODE OF OUTDOOR UNIT

13.1 Error Codes

List of error codes and their corrective actions.

14 FOLLOWING SYMPTOMS ARE NOT HEAT PUMP TROUBLES

15 TROUBLE SHOOTING

16 TECHNICAL SPECIFICATIONS

17 IMPORTANT INFORMATION FOR THE USED REFRIGERANT

Olimpia splendid SHERPA S2 E 12 Specifications

General IconGeneral
BrandOlimpia splendid
ModelSHERPA S2 E 12
CategoryHeat Pump
LanguageEnglish

Related product manuals