MODEL 702, 702SE and 702SS BUN SLICERS
REV. 8-28-96 0702S20010
MAINTENANCE/CLEANING/LUBRICATION
WARNING
NEVER ATTEMPT TO CLEAN OR SERVICE THIS MACHINE UNTIL IT
HAS BEEN DISCONNECTED FROM THE POWER SUPPLY AND YOU
ARE SURE THE BLADE HAS STOPPED. ALSO REMEMBER TO USE
CARE WHENEVER YOU ARE WORKING NEAR THE BLADE.
MAINTENANCE
Other than normal cleaning and occasional blade replacement little other regular
maintenance is required.
CLEANING
Use a mild detergent solution or spray cleaner on all exterior and interior surfaces as
necessary. Periodically remove the overhead guard assembly and blade guard, then
brush, or vacuum, all foreign material from below the chute and from the blade
compartment.
• Remove the blade guard by removing the three hex head screws which hold it in
place. Lift it clear of the machine and set it one side.
• Remove the outside side guide and chute guard assembly by
completely removing both knobs which secure it in place.
The blade will need to be removed and cleaned occasionally due to product build up,
especially when cutting fruity or sticky breads. See “Changing the Blade” latter in this
manual for instruction on how to remove the blade
.
WARNING
ALWAYS USE CARE WHEN HANDLING AND CLEANING KNIVES.
LUBRICATION
No lubrication is required. The motor is equipped with pre-lubricated sealed bearings
which require NO lubrication, DO NOT
attempt to oil or grease the motor.
To Next Page
Loading...
Need help?
General
