Cont. Ventis Class-A Chimney Components (Part No.)
Masonry Transition
Plate
(VA-TPxx)
Wall Pass-Thru Thimble
(VA-WPTxx)
(Thimble) Finishing Collar
(VA-FCxx)
Square Storm Collar
(VA-SCSQxx)
Note: xx = diameter; yy = length; zzz = type of stainless steel (inner pipe); vv = pitch or angle
Approved Installations
Use of any parts or materials not specified in this installation manual may not provide a listed system and may
void the Ventis Class-A warranty. Do not attempt matching Ventis components or pipe sections with another
manufacturer’s products. Do not use damaged or modified parts.
Safety Considerations
Caution: The ends of the chimney sections, edges of the cap, roof flashings, tee and other components
can be sharp! We strongly recommend the use of gloves during installation.
Warning: Watch out for overhead power lines during installation. Be sure to check above and around
the chimney for antennas, power lines, or any other obstacles before beginning the installation. Be sure
that the chimney does not come in contact with electrical or any other wires.
To Next Page
Loading...