12
- Rotate the condenser turret (23) until the BF (brightfield) mark is visible.
- Loosen the clamping knob from the DIC prism slider and disengage the transmitted
light DIC prism slider (26) from the light path.
- Pull the polarizer (25) out of the light path.
- Pull the reflected light analyser (U-AN) (24) out of the light path.
- Turn the light intensity down using the brightness adjustment knob (3).
- Turn off the halogen light switch (1) to “0” (OFF).
- Cover the microscope when the mercury bulb is cooled down (15 minutes after it was
turned off).
- Leave the room CLEAN and TIDY!
This Manual: http://www.manuallib.com/file/2605418
To Next Page
Loading...
