14
18. When finished:
- Lower the stage by turning the focus knob (10) towards you and remove the slide
with your specimen from the stage (7).
- Turn the nosepiece (12) back until the 10x objective is into place.
- If the100x objective was used, clean the lens carefully with lens paper ONLY (do
not use Kimwhipes).
- Pull the polarizer (25) out of the light path.
- Pull the reflected light analyser (U-AN) (24) out of the light path.
- Turn the light intensity down using the brightness adjustment knob (3).
- Turn off the halogen light switch (1) to “0” (OFF).
- Cover the microscope.
- Leave the room CLEAN and TIDY!
This Manual: http://www.manuallib.com/file/2605418
To Next Page
Loading...
