13
En
Inserting/Removing the memory card (SmartMedia)
This camera uses SmartMedia card to record pictures. This manual uses the
term “card” when referring to SmartMedia.
Be sure to use a 3 V (3.3 V) card. Non-Olympus 3 V (3.3 V) cards must be
formatted with the camera. Do not use a 5 V card or a 2 MB card.
1 Make sure the camera is turned off (i.e. the
mode dial is set to OFF). Open the card cover.
2 Inserting the card
Insert the card fully with the contact area facing
towards the monitor side. Insert until you feel it
locked into place.
● Hold the card in a straight orientation to the card
slot. Do not attempt to insert the card at an
angle.
● Note the orientation of the card. If it is inserted
incorrectly, it may become jammed.
Removing the card
Push in the card lightly to unlock it, then pull it
out.
3 Close the card cover securely until it clicks.
Mode dial
Card cover
Power on/off
1 Before turning the camera on, press
the tabs on the lens cap to remove it.
2 Set the mode dial to P, A/S/M/ ,
or .
● The camera turns on.
● The lens moves out when the mode dial
is not set to .
3 Set the mode dial to OFF.
● The power turns off.
Lens cap
Mode dial
1 C4000ZBasic-E1 02.6.17 10:44 AM Page 13
To Next Page
Loading...
