14
En
GETTING STARTED (Cont.)
Date/time setting
1 Set the mode dial to P.
2 Press .
● The monitor turns on automatically and the top menu appears.
3 Press í on the arrow pad to select MODE MENU.
4 Press ñ to select SETUP, then press í.
5 Press Ññ to select , then press í.
6 When is selected on the screen, press Ññ to select the date
format.
● Select any one of the following formats:
D-M-Y (Day/Month/Year)
M-D-Y (Month/Day/Year)
Y-M-D (Year/Month/Day)
● This step and the following steps show the procedure used when the
date and time settings are set to Y-M-D.
7 Press í to move to the year (Y) setting.
8 Press Ññ to set the year. When the year is set, press í to move to
the month (M) setting.
● Repeat this procedure until the date and time are completely set.
● To move back to the previous setting, press
É.
● The first two digits of the year cannot be changed.
● The camera can only display the time in “number of hours”, or what is
commonly known as military time. Consequently, 2 p.m. would be 14:00
hours, or 12:00 hours + 2:00 hours =14:00 hours.
9 Press .
● If is pressed again, the menu will disappear.
● For a more accurate setting, do not press until the time is actually at
00 seconds. The camera’s built-in clock starts when you press this
button.
0 To turn the camera off, set the mode dial to OFF.
● The date setting will be canceled if the camera is left with no batteries for
approximately 1 hour. If this happens, you will need to set the date again.
1 C4000ZBasic-E1 02.6.17 10:44 AM Page 14
To Next Page
Loading...
