18
1
Getting started
Loading the batteries
This camera uses two CR-V3 lithium battery packs or four AA (R6) NiMH
batteries, NiCd batteries, alkaline batteries or lithium batteries.
1
Make sure the camera is turned off.
• The monitor is off.
• The viewfinder is off.
• The lens is not extended.
2
Slide the battery
compartment lock from
=
to
)
.
3
Slide the battery
compartment cover in the direction of
A
, then lift in the direction of
B
.
• Use the ball of your finger to slide the cover.
Do not use your fingernail as this could result
in injury.
4
Insert the batteries, making sure that
they are correctly oriented as shown in the illustration.
• When using rechargeable AA (R6) batteries, charge them before use.
When using AA (R6) batteries
When using CR-V3 lithium battery packs
The correct way to insert the AA (R6) batteries
is indicated on the bottom of the camera.
• CR-V3 lithium batteries cannot be recharged.
• Do not peel off the label from a CR-V3 lithium battery pack.
• Manganese (zinc-carbon) batteries cannot be used.
Important
Battery
compartment
cover
Battery
compartment
lock
B
A
Battery
alignment
To Next Page
Loading...
