16 En
En
J SETTING THE DATE AND TIME
1 Set the mode dial to C and turn the camera on.
• MODE MENU is displayed.
2 Press ac to select the SETUP tab, then press d
3 Press ac to select X, then press d.
• The green frame moves to the selected item.
• Press c repeatedly until X is displayed on the monitor.
4 Press ac to select one of the following date formats: Y-M-D
(Year/Month/Day), M-D-Y (Month/Day/Year), D-M-Y (Day/Month/
Year). Then press d.
• Move to the year setting.
• The following steps show the procedure used when the date and time settings
are set to Y-M-D.
5 Press ac to set the year, then press d to move to the month
setting.
• To move back to the previous setting, press b. The first two digits of the year
are fixed.
6 Repeat this procedure until the date and time are completely set.
• The time is displayed in the 24-hour format.
For example, 2pm will be displayed as 14:00.
7 Press e.
• For a more accurate setting, press e when the time signal hits 00 seconds.
8 To turn the camera off, press the power switch again.
• The date and time settings will be canceled if the camera is left without
the battery for a few days.
Note
basic_e_d4155_6.fm Page 16 Monday, December 8, 2003 10:02 AM
To Next Page
Loading...
