Olympus CAMEDIA C480 Zoom User Manual (English)

Questions and Answers:

J
Jamie BurnsAug 18, 2025
Why my Olympus CAMEDIA C480 Zoom does not turn on?
- C
  chambersdominiqueAug 18, 2025
  If your Olympus Digital Camera does not turn on or the function buttons are unresponsive, try the following: * Ensure the power is on by pressing the POWER switch. * Check and correctly reload the batteries. * Replace or charge the batteries if they are exhausted. * Warm the batteries if cold is affecting their performance by placing them in your pocket. * Operate the camera using the shutter button or # if it's in sleep mode. * Note that the camera will not operate while connected to a computer.
K
Katherine MartinezAug 20, 2025
Why is the monitor hard to see on my Olympus CAMEDIA C480 Zoom?
- K
  Karen CarrAug 20, 2025
  If your Olympus Digital Camera's monitor is hard to see: * Turn the camera off and wait until it dries before turning it on again, if there is condensation inside the camera. * Adjust monitor brightness using [s]. * Block the sunlight with your hand while taking pictures if the monitor is exposed to direct sunlight.
A
andrew11Aug 23, 2025
Why Olympus CAMEDIA C480 Zoom Digital Camera pictures are too dark?
- T
  Todd PaceAug 23, 2025
  If your Olympus Digital Camera is producing pictures that are too dark, consider these solutions: * Hold the camera correctly, keeping your fingers away from the flash. * Ensure you are shooting within the flash working range. * If the subject is too small and backlit, set the flash mode to [#] before taking the picture. * If using sequential shooting mode, be aware that higher shutter speeds may result in darker pictures; set [j] in the top menu to [OFF].
S
Sara PetersenAug 26, 2025
How to fix too bright picture on Olympus CAMEDIA C480 Zoom Digital Camera?
- J
  Jessica RobertsAug 26, 2025
  If your Olympus Digital Camera is producing pictures that are too bright: * Select a flash mode other than [#], if the flash was set to [#]. * Adjust the exposure compensation toward minus (–) if the center of the subject is too dark, as this can cause the surrounding area to appear too bright.
J
Jasmine MclaughlinAug 28, 2025
How to fix out of focus picture on Olympus CAMEDIA C480 Zoom Digital Camera?
- K
  Kathleen UnderwoodAug 28, 2025
  If your Olympus Digital Camera's picture is out of focus: * Move further away from the subject. For shots closer than 20 cm (7.9") with maximum zoom wide, use super macro mode. * Use the focus lock to focus on your subject, if auto focus is not possible. * Turn the camera off and wait until it dries before turning it on again, if there is condensation on the lens.
M
martin06Aug 30, 2025
How to stop my Olympus CAMEDIA C480 Zoom Digital Camera from resetting settings?
- T
  Timothy GallegosAug 30, 2025
  If your Olympus Digital Camera settings revert to factory defaults when turned off, set [ALL RESET] to [OFF].
P
pamela62Sep 2, 2025
Why Olympus CAMEDIA C480 Zoom Digital Camera battery drains so fast?
- R
  Robert Romero Jr.Sep 2, 2025
  If the battery run time of your Olympus Digital Camera is brief: * Keep the camera warm by putting it inside your coat or clothing, as battery performance deteriorates in low temperatures. * Replace or charge the batteries when battery consumption fluctuates considerably, as the camera may turn off without displaying the battery warning indicator.
S
Samuel EllisSep 4, 2025
How to fix single-frame erase on Olympus CAMEDIA C480 Zoom Digital Camera?
- I
  icruzSep 5, 2025
  If single-frame erase and all-frame erase cannot be performed on your Olympus Digital Camera, cancel the protection of the pictures.
T
Tony ValentineSep 7, 2025
What to do if my Olympus CAMEDIA C480 Zoom Digital Camera doesn't take a picture when I press the shutter button?
- B
  brian09Sep 7, 2025
  If your Olympus Digital Camera isn't taking pictures when you press the shutter button, consider these possibilities: * Replace or charge the batteries if they are exhausted. * Ensure the camera is in shooting mode by pressing #. * Wait for the flash to finish charging (the # indication stops blinking). * Make sure the power is on by pressing the POWER switch. * Erase unwanted pictures or insert a new card if the memory is full. Download important images to a computer before erasing. * If the battery power was exhausted during shooting, replace or charge the batteries and wait until the card access lamp stops blinking. * Wait until there is space in the memory gauge.
R
Ryan ChoiSep 9, 2025
Why pictures do not appear on the monitor of my Olympus CAMEDIA C480 Zoom?
- V
  vobrienSep 9, 2025
  If pictures you've taken aren't showing up on the monitor of your Olympus Digital Camera: * Ensure the power is on in playback mode by pressing $. * Switch to playback mode by pressing $ if the camera is in shooting mode. * Record pictures if [NO PICTURE] is displayed, indicating there are no pictures in the internal memory or card. * If there is a problem with the card, see “Error codes”.