Olympus CAMEDIA E-20 - Page 83

81
5
2
On the arrow pad, press or
to move the green highlight to
(or / ).
(To jump to the above icon, press first.)
3
On the arrow pad, press to
move the green highlight to PS
mode.
4
Press the button.
The PS mode is selected, and the green
highlight moves to .
(To cancel the setting, press the menu
button instead of the button.)
Press the button again to close the menu.
5
Check that the record mode
indicator is blinking and the
icon is displayed in the control
panel.
The record mode may have been
changed.
PS mode and Quality Settings
• The SHQ, HQ, and SQ settings can be used. (The RAW and TIFF setting cannot be used.)
Note
• The maximum number of sequential shots which can be taken using the burst mode increases to
seven in the PS mode.
• In the PS mode, up to six memory gauge bars are lit. (One memory gauge bar indicates one shot
image in the buffer.) After taking a seventh shot, the memory gauge starts blinking. If the memory
gauge is blinking, you cannot continue shooting.
• Smear can occur when you are taking a picture in a bright place, for example, under a bright sky.
• Colors may be blurred, or jaggies may appear, along angled lines in the shot image.
3
2
4
Control panel
5