32
Chapter 3 Cleaning, Disinfection and Sterilization Procedures
EVIS EXERA GIF/CF/PCF TYPE 160 Series REPROCESSING MANUAL
1. Align the OER/ETD/EW character (see Figure 3.16 a), the EW character or
KC/TD character (see Figure 3.16 b) on the water-resistant cap with mark 2
on the electrical connector housing.
2. Align the pin on the electrical connector with the groove on the
water-resistant cap.
3. Push the water-resistant cap into position and rotate it clockwise until it
stops (approximately 45).
Figure 3.16
To Next Page
Loading...
