Olympus CHS - Page 23

w
o
=>
c:J
c:J
Z
t-
O
o
I
r.n
w
...J
co
:J
o
a:
t-
IJ
- --
T' ... • • ....
I ... ~ .
. "- - ~ . .
- -
Trouble
Cause
J ___
Remedy
f---
-
6.
Electric system
a)
Illuminator
is 100
bright
Voltage 5elector swi tch is n01 matched
Contorm the switch 10 [he finevohage.
with
the voltage control with the line VOltage.
{p.6)
dial
the
lowest
~. __ .
-
even
at
Line voltage
is too high. Adjust the line voltage with a variable
position (closest
to the
'Jol~age ,ransformer.
operator).
~
Bulb is not a standard one.
Use a standard bulb. (p. 6)
b) Output
voltage fa" the il- Voltage selec10r switch is not matched
Conform the switch to the IJnevoltage.
lumina tor cannot
be can· with the line voltage.
(p.6)
troled
{too
high or
too
Line voltage Is 100 high (or too ~
w).
Adjust the line voltage with a variable
1m-v).
VOltage Iransformer.
_.
------
cl
Light flickers and intensity
Line voltage. is unstable.
Use 0 voltage stabilizer
is unstable.
--
Filament of the bulb is likely to burn
Replace the defective bulb.
(p.6)
out.
.-
Loose electric cords Secur.e the connections. (p.
8)
_.
d)
Fuse burns out too often.
F use is nOT a standard one. Use a standard fuse. (p. 9)
Vol age selector svvitch is not ma'ched
Conforrn the switch to the line voltage.
.. vith the line VOltage.
(p.6)
--- ---
e} Bulb does not light Fuse is gone.
Repl<Jce the 1ure,
(p.9)
I
Bulb IS burned out. Replace the bulb. (p. 6)
Loose el~c:trir:: connections.
Secure
the connections.
{p
8)
--
---
--
f)
Reduced bulb life
Voltage
selector switch is not matched Conform t he- selector
switch to
the
with the line voltage. line voltage. (p.61
Bulb is not a standard one.
Use a standard bulb. (p. 6)
Bulb was bvervolted too long.
Reduce bu
Ib voltage.
(p.9)
11-----------------------------