17
Using the Variable Control Voice Actuator (VCVA)
7
Start the recording.
When the sound volume is lower than the
preset pause sound level, recording
automatically pauses after approximately
1 second, and “STANDBY” flashes on the
display. The record/play indicator lamp
glows when recording starts and flashes
when recording pauses.
Adjust the start/stop actuation level
Using the VOLUME control, adjust the start/stop
actuation level.
The pause sound level can be set to any of 15 different
values. The higher the value, the higher the sound sensitivity.
At the highest setting, even a small sound will activate
recording.
The VCVA pause sound level can be adjusted according to the
ambient (background) noise.
·······················································································································································
Notes
• The start/stop actuation level also varies depending on the selected microphone sensitivity mode. (☞ P.19)
• To ensure successful recordings, prior testing and adjustment of the start/stop actuation level is recommended.
Hi
Low
To Next Page
Loading...
