Olympus DS-50 - Voice Recognition in ViaVoice; Sound Card Selection and Audio Setup

74
7
Disconnecting from Your PC
1
Click the on the task bar
located at the lower-right
corner of the screen. Click
[Safely Remove Hardware].
The drive letter will differ
depending on the PC being
used.
2
Disconnect the USB cable.
Connecting to Your PC
..................................................................................................................................................
Notes
• NEVER disconnect the USB while the record/play indicator light is flashing. If you do, the data will be
destroyed.
• When the recorder is connected to a PC, the power will be supplied from the USB cable.
• Refer to the user’s manual for your PC regarding the USB port or USB hub on your PC.
• Be sure that you connect the USB cable either directly to the USB port on your PC or the self-power (AC
adapter connection) USB hub.
• Be sure to push the cable connector all the way in. Otherwise, the recorder may not operate properly.
• Cancel Hold mode.
Connecting to Your PC
1