4 EPOCH 650 — Getting Started Guide
To Replace the Battery
1. Turn off the EPOCH 650 and disconnect DC power.
2. Fully unfold the stand at the back of the EPOCH 650.
3. Loosen the two thumb screws securing the battery compartment cover and remove the cover.
4. Remove the used battery.
5. Install a new battery, aligning the connectors on the battery with the battery compartment
connectors.
6. Reinstall the battery cover (fit the tab on the cover into the slot on the bottom of the instrument).
7. Tighten the two thumb screws to complete the installation.
To Install the microSD Card
1. Remove the microSD card from its packaging.
2. Loosen the two thumb screws and open the EPOCH 650 side door.
3. Hold the microSD card so that the metal pins face toward the front of the instrument.
4. Gently slide the card into the microSD slot until it clicks.
To remove the microSD card, gently push the card into the EPOCH 650 and release. A spring-loaded
mechanism will partially eject the card, and then you can grasp and remove it from the EPOCH 650.
Lithium-ion battery (600-BAT-L-3 [U8051431])
Stand
Battery compartment cover
microSD card (P/N: MICROSD-ADP-2GB [U8779307])
To Next Page
Loading...
