Chapter 3 Preparation and Inspection
61
EVIS LUCERA GIF/CF/PCF TYPE 260 Series OPERATION MANUAL
Chapter 3 Preparation and Inspection
Before each case, prepare and inspect this instrument as instructed below.
Inspect other equipment to be used with this instrument as instructed in their
respective instruction manuals. Should any irregularity be observed after
inspection, follow the instructions as described in Chapter 5, “Troubleshooting”.
If this instrument malfunctions, do not use it. Return it to Olympus for repair as
described in Section 5.3, “Returning the endoscope for repair” on page 118.
• Using an endoscope that is not functioning properly may
compromise patient or operator safety and may result in
more severe equipment damage.
• This instrument was not cleaned, disinfected, or sterilized
before shipment. Before using this instrument for the first
time, reprocess it according to the instructions as described
in the endoscope’s companion “REPROCESSING MANUAL”
with your endoscope model listed on the cover.
3.1 Preparation of the equipment
Prepare the equipment shown in Figure 3.1 (for compatibility, see the “System
chart” in the Appendix) and all personal protective equipment, such as eyewear,
face mask, moisture-resistant clothing, and chemical-resistant gloves that fit
properly and are long enough so that your skin is not exposed. Refer to the
respective instruction manuals for each piece of equipment.
To Next Page
Loading...