Chapter 3 Preparation and Inspection
75
EVIS LUCERA GIF/CF/PCF TYPE 260 Series OPERATION MANUAL
Attaching the auxiliary water inlet cap (for endoscopes with
auxiliary water feeding only)
If the auxiliary water inlet cap is not attached, attach the fitting ring to the
auxiliary water inlet on the endoscope connector (see Figure 3.19).
Figure 3.19
3.5 Inspection and connection of ancillary
equipment
Inspection of ancillary equipment
• Attach the water container to the specified receptacle on the
trolley (cart) or on the light source. If the water container is
attached anywhere else, water may drip from the water
container’s water supply tube, and equipment malfunction
can result.
• Take care not to spill water from the water container’s
connection adapter when detaching the connection adapter
from the endoscope. Spilled water could splash on the
equipment, and may cause equipment malfunction.
Prepare and inspect the light source, video system center, monitor, magnification
controller (for CF-H260AZL/I only), endoscope position detecting unit (for
CF-Q260DL/I, CF-H260DL/I only), water container, suction pump, and
EndoTherapy accessories as described in their respective instruction manuals.
Fitting ring
Auxiliary water inlet cap
Auxiliary water inlet
Endoscope connector
To Next Page
Loading...