38
EN
Using OLYMPUS Master 2
System requirements and
installation of OLYMPUS
Master 2
Install the OLYMPUS Master 2 software by
referring to the included installation guide.
Connecting the camera to a
computer
1
Make sure the camera is turned off.
The monitor is off.
The lens is retracted.
2
Connect the camera to a computer.
USB cable (supplied)
USB connector
Locate the position of the USB port by
referring to your computer’s instructions
manual.
●
●
3
Press the n button.
The camera turns on.
EASY PRINT
USB
SET
OK
EXIT
CUSTOM PRINT
PC
4
Use kl to select [PC], and
press the B button.
The computer automatically detects the camera as
a new device on the fi rst connection.
Windows
After the computer detects the camera, a
message indicating setup completion appears.
Confi rm the message and click “OK”. The
camera is recognized as a removable disk.
Macintosh
If iPhoto has started, exit iPhoto and start
OLYMPUS Master 2.
While the camera is connected to the
computer, shooting functions are disabled.
Connecting the camera to a computer via a
USB hub may cause unstable operation.
When [MTP] is set for the submenu that
appears by pressing n after selecting [PC]
in Step 3, images cannot be transferred to a
computer using OLYMPUS Master 2.
●
●
To Next Page
Loading...
