20
EN
Other settingOther setting
Setting a beeping sound to indicate that the fl ash is ready to fi re
1
Hold down the BEEP button until the BEEP lamp lights up.
• To disable the beeping sound, hold down the BEEP button until the BEEP
lamp turns off.
Safety Precautions
Read WARNINGS and CAUTIONS thoroughly to ensure safe usage. These
safety precautions protect the users and others and prevent property damage.
WARNING
Failure to observe the precautions indicated by this symbol
may result in injury or death.
• Do not use fl ash in places where it may be exposed to fl ammable or explosive
gas. Otherwise, fi re ignition or explosion may result.
• Do not directly solder the product or modify, remodel, or disassemble.
• Do not cover the light emitting area of the fl ash with your hand, and do not
touch the light emitting area after continuous fi ring. It may burn your skin.
• Water and foreign matter inside of the device may cause fi re or electric shock.
If the device is immersed in or exposed to water or foreign matter is found
inside of the device, turn off the power immediately and remove batteries with
care. Contact your dealer or consult an Olympus Authorized Service Station.
• To prevent a traffi c accident, do not direct the fl ash at a person operating a
motor vehicle.
• Do not use the fl ash or AF illuminator in close proximity to others (especially
infants). Keep the fl ash out of reach of children. Light from the fl ash can cause
visual impairment.
• To prevent a short circuit, do not use batteries with a damaged external seal
(insulation coating).
• Do not mix old and new batteries, or batteries made by different manufacturers.
• Do not connect substances such as metal to the (+) or (–) of batteries.
To Next Page
Loading...
