Olympus i-SPEED LT - Trigger Setup Menu; Trigger Mode Control; Trigger Edge Control

Software reference (CDU) i--SPEED LT
41
i--SPEED LT, i--SPEED 2
9. Trigger Setup Menu
This menu makes available all the items which relate to the live
view systems of the camera. It would be of benefit to read Chapter
8 “Understanding the Olympus i-- SPEED LT” for further
descriptions on several of the terms and phrases used in this
section.
Access: i-- SPEED LT Home
' Setup ' Trigger Setup
Options: Trigger mode Trigger edge Trigger pos Burst time
Clear last Clear mem
S The CDU will display the live image
` Trigger Mode Control
This control is used to change the camera into Record On
Command (ROC) mode or Burst Record On Command (BROC)
mode.
` Trigger Edge Control
This control sets the trigger detection system to wait for a rising
edge or a falling edge on the trigger input connection.
NOTE
This control is not available in ROC mode, since ROC is
not edge triggered.
This value is stored in non--volatile memory. After a
power cycle, it will be set to the last used position.