Olympus i-SPEED LT - Page 71

Software reference (CDU) i--SPEED 2
69
i--SPEED LT, i--SPEED 2
` WB Set Control
This control activates the automatic white balance function. Before
pressing this control, the user must place a pure white reference
(sheet of paper etc.) if front of the camera, completely filling the field
of view. This must not be removed until the white balance is
complete. An on screen message shows the status of the white
balance process.
Please refer to Chapter 8 “Understanding the Oly mpus i--SPEED
2”
for a further description.
NOTE
The control is only available if the white balance mode
is set to automatic.
Once set, the white balance values will be stored in
non --volatile memory. Thus if camera power is removed,
the camera will return to the user set white balance
values.