30
4.2 Inspection workflow
OME-L200 INSTRUCTION MANUAL
Ch.4
Refer to the inspection workflow below. Follow each step of the workflow for inspection of this
instrument before use.
4.2 Inspection workflow
1
Confirm that this instrument is turned ON.
Section 4.3 on page 31
2
Confirm that the illumination light is output from the
microscope section of the surgical microscope.
Section 4.4 on page 33
3
Confirm the functioning of the spare lamp.
Section 4.5 on page 34
4
Confirm the functioning of the spare lamp brightness
control.
Section 4.6 on page 36
5
Turn the instrument OFF
(when it is not to be used immediately after the
inspection).
Section 4.7 on page 38
To Next Page
Loading...
