40
5.2 Turning the instrument and illumination lamp ON
OME-L200 INSTRUCTION MANUAL
Ch.5
• Do not approach a cord connected to the electrosurgical unit to this instrument and
the ancillary equipment combined with it. Otherwise, malfunction may be caused
during the high-frequency output.
• A spray-type lubricant, anesthetic, alcohol or other chemical liquid should be used
at a distance from this instrument so that it is not spilt on this instrument. Otherwise,
the chemical entering this instrument through a ventilation grille may cause
equipment failure.
Always set the power switch of the LED light source to “ (ON)” before turning the
surgical microscope ON. If the LED light source is turned ON after the surgical
microscope, malfunction may result.
5.2 Turning the instrument and illumination lamp
ON
To Next Page
Loading...
