16
Chapter 3 Cleaning, Disinfection and Sterilization Procedures
OSF-3 ENDOSCOPE REPROCESSING MANUAL
ETO Cap (MB-156)
Installed on the Venting Connector of the Endoscope Connector to allow ETO
gas sterilization (see Figure 3.4).
Figure 3.4
Channel-opening Cleaning Brush (MH-507)
The Channel-opening Cleaning Brush is used to brush the outer surface of the
Distal End of the endoscope, the Suction Cylinder and the Instrument Channel
Opening (see Figure 3.5).
Figure 3.5
Notice Card
To Next Page
Loading...
Need help?
General
