If the camera does not work as intended, or if
an error message is displayed on the screen,
and you are unsure of what to do, refer to the
information below to fix the problem(s).
...................TroubleshQoting .................................................................................................................................................................................
Sattery : :: :::
"The camera does not work e_e_:;W_n
battery is installed"
• Insert recharged battery in the correci di}ecti_.
"Charging the battery" (p. 10), _i_g ihe _a_ery
and the xa-Picture Card TM (sold se_raieiyt i_to
the camera" (p. I1)
• Battery performance may have been reduced
temporarily due to low temperature. Take the
battery out of the camera, and warm it by putting it
in your pocket for a while•
Card/Internal memory
"An error message is displayed"
"Error message" (p. 57)
Shutter button
"No picture is taken when the shutt_
button is pressed" ;
• Cancel sleep mode.
To save battery power, the camera automatically
goes into sleep mode and the monitor turns off
if there is no operation after 3 minutes When the
camera is turned on. No picture is taken even if
the shutter button is fully pressed in this mode•
Operate the zoom button or other buttons to
restore the camera from sleep mode before taking
a picture• If the camera is left for f 5 minutes, it
automatically turns off. Press the ON/OFF button to
turn on the camera•
® Set the mode dial to a position other than []_j.
® Wait until _.(flash charge) stops blinking before
taking pictures•
/i11:_¸:e x ....................
Monitor
"Difficult to see"
® Condensation *_may have formed. Turn offthe
p.......dwaitforth....... _dytob.....
acclimated to th........ ding temperat ...... d dr_
out before taking pictures.
• Dew drops can form in the camer_ whe:_ !t is
suddenly taken from a cold location into a _l'm
humid room.
"Vertical lines appear on the screen"
® Vertical lines may appear on the screen at
times such as when the camera is pointed at an
extremely bright subject under a clear sky. The
lines do not appear, however, in the final image.
"The light is caught in the picture"
® Shooting with flash in dark situations results in
an image with many flash reflections on dust in
the air.
Date and time function
default setting"
® If the battery is removed an_ ieff:ou{ of the camera
for about 1 day.2,the date and time settings return
to the default setting and must be reset•
•2 The time until the date and time settings return
to the default setting varies depending on how
long the battery have been loaded.
"Setting the date and time" (p. I3)
Others
"Noises occur from the inside of the
camera in shooting standby mode"
® Auto focusing operation may cause lens
movement noises even if you do not make any
camera operation.
To Next Page
Loading...
