Olympus SZ3060 - 4. OPTICAL ADJUSTMENT

SZ3060·4060·4045
C. REASSEMBLING PROCEDURE
No. C-11
4. Optical Adjustment
r-------------------------------------~ 4-1 Prepare for the adjustment.
(1) Attach the BI unit to the ZB unit.
SCREW AB 3x8SA 3 pes.
* Push the BI unit in the arrow
direction and fasten it.
(2) Attach the sleeve to the BI unit.
(3)
(4)
SCREW AB 3x8SA 8 pes.
* The helicoid provided side should
be the left side. It should be
fastened securely at the middle
position of tube play.
Insert the adjusting ADAPTER Q)
into SZ-ST @ and fasten it.
Screw the longer ADAPTER@) into
the STANDARD OBJECTIVE ® , and
screw it further into the BODY.
* The ADAPTER @) is included .in
the STANDARD OBJECTIVE @) .
(5) Insert the BODY into the adjusting
ADAPTER 0.
CD Jig
®@)Jig
®Jig
Adjusting adapter
(SZKC002)
STANDARD OBJECTIVE
(SZKCOOl)
STANDARD EYEPIECE
(KN0024)
4-2 Adjust the parfocality.
(1) Adjust the scale "0" of the LEFT
SLEEVE
ASSEMBLY to the index line
of TUBE ASSEMBLY by rotating the
helicoid ring and fasten it.
* It is recommendable to fasten
it tentatively with a tape.
(2) Fasten the right sleeve at the
position where it becomes the
same level as the left sleeve.
SCREW ACU 2x3UO 2 pes