SZX7
24
Bring to the center
of the stroke.
Adjusting the focus (Fig. 21)
1. Rotate the focus adjustment knob @ of the SZ2-FO up/down moving
stage to bring the stage at the center of the focusing stroke.
2. Place a specimen on the stage and rotate the focus adjustment knob ²
on the side of the stand in use to bring the specimen into approximate
focus. And then adjust the accurate focus using the focus adjustment
knob @ of the up/down moving stage.
5
Applicable Stands and Restrictions
Stands Applicable Objectives Restrictions
· Standard stand
SZ2-ST
SZX-ST
· Large stand
SZ-STL
SZX-STL
0.5X to 1.5X None
2X
With the SZ2-ST, install the SZ2-FO so
that the focus adjustment knobs come
on the side of the operator.
· Transmitted illumination stand
SZ2-ILA
Peripheral part of image is cut off at
low magnifications.
The SZ2-ST is also required.
· Transmitted illumination stand
SZX-ILLK
· High-class transmitted illumination
stand
SZX-ILLB2
· Transmitted brightfield/darkfield illu-
mination stand
SZX-ILLD2
The restrictions are identical whether or not the stage adapter is used.
(Refer to the instruction manual for the SZX illumination stand.)
The transmitted light illumination field may be limited depending on the
diameter of the hole on the stage center plate in use.
#Darkfield observation is not available with the SZX-ILLD2.
#The brightness drops when a frost filter is used.
²
1
Fig. 21
To Next Page
Loading...
