Olympus UHI-4 - Page 3

UHI-4 Insufflator Quick Reference Guide
Disclaimer: Information provided in this guide is not exhaustive. Please refer to the complete Instructions For Use for each
item of equipment which should be thoroughlyread and understoodprior to handling, use and storage of the equipment.
Insufflator Controls Troubleshooting
Smoke Evacuation
Connector
Power Switch
Set Pressure Flow Rate
Actual Pressure Volume Indicator
CO
2
Connector Smoke Evacuation
Speed
Start/Stop
Low or no pressure
• Check insufflation tubing connected to insufflator, switched on and tap on port turned on.
• Check gas level and that gas cylinder is turned on Increase flow rate or pressure.
Excessive pressure alarm continuously sounds
• The high pressure alarm will sound if the patient anaesthetics are no longer effective,
consult the anaesthetist.
Smoke Evacuation does not work
• Check the smoke evacuation speed is not set to OFF.
• The flow rate on the insufflator is set to MEDIUM or HIGH
Useful Part Numbers
WA95005A Insufflation tubing box 20
WA95007A
Smoke Evacuation tubing box 20
Issue 1
05/02/2021
KMF-08929
NCDR 02867