Chapter 5 Operation
181
VISERA VIDEO SYSTEM CENTER OTV-S7V
8. Depress the menu switches “ ” or “ ”, or the “///” key on the
keyboard to set the number to “slow motion frequency” of the strobe light
source.
9. Depress the menu switch “ ” for approximately 1 second or the “Esc” key
on the keyboard to enter all settings.
The motion frequency setting is retained when the power is
turned OFF and the power cord is disconnected.
Displaying the strobe images
The strobe images can be displayed by controlling the menu switches or
keyboard (optional).
Display the strobe images by pressing a remote control
switch
1. Refer to Section 5.12, “Remote control switches” and set the “MULTI
FREEZE” function to a remote control switch on the camera head or
videoscope.
2. Pressing the remote control switch toggles between turning the strobe
images on and off (see Figure 5.132).
Figure 5.132
Strobe images are displayed in the order No.1 to No.4 (When
the “DIVISION NUMBER” is “4”) or No.1 to No.9 (When the
“DIVISION NUMBER” is “9”) shown in Figure 5.132.
123
4
5
6
7
8
9
12
3
4
When the “DIVISION NUMBER” is “4”
When the “DIVISION NUMBER” is “9”
To Next Page
Loading...
Need help?
General
