6
Troubleshooting
56
EN
Problem Possible cause Solution
The display is blank.
The battery is not inserted
properly.
Check that the positive and negative
terminals of the battery are placed
correctly (☞ P.8).
The remaining battery power
is low.
Replace the battery (☞P.8).
The power is OFF.
Turn the power ON (☞P.9).
Unable to operate the
voice recorder.
The remaining battery power
is low.
Replace the battery (☞P.8).
The power is OFF.
Turn the power ON (☞P.9).
The voice recorder is in HOLD
mode.
Release HOLD mode (☞ P.12).
Unable to record.
There is no remaining memory.
Erase unneeded files (☞P.32).
The maximum number of
recordable files has been reached.
Select another folder (☞P.14).
Playback is inaudible.
The earphones are connected to
the earphone jack.
To output the playback through the built-
in speaker, disconnect the earphones.
The volume is set to [00].
Adjust the volume (☞ P.24).
The recording is too
quiet.
A low recording level has been
set.
Redo recording after setting the recording
level to [High] (☞P.38).
The output level of the connected
external device may be too low.
Adjust the output level of the external
device.
Troubleshooting
To Next Page
Loading...
