17
User ManualDesigned to Enhance Built-in Oven
Cleaning & Maintenance
Prior to Cleaning Your Oven
• Before any maintenance and cleaning, turn off the appliance
and disconnect the power.
• Set all controls in their off positions:
• Wait until the inside of the unit is not hot but only slightly
warm—cleaning is easier than when warm.
• Clean the surface of the unit with a damp cloth, soft brush
or fine sponge and then wipe dry.
• In case of heavy soiling, use hot water with non-abrasive
cleaning product.
• For cleaning the oven door glass, do not use abrasive cleaners
or sharp metal scrapers, as these can scratch the surface
or lead to the glass being damaged.
• Never leave acidic substances (lemon juice, vinegar) on
stainless steel parts.
• Do not use a high pressure cleaner for cleaning the unit.
• The baking tray and wire shelving may be washed in mild
detergent.
To extend the life of your oven, it must be cleaned frequently,
keeping in mind that:
• The enamelled, steel or aluminium parts should be washed
with lukewarm water without using any abrasive powders or
corrosive substances which could ruin them; stainless steel
could get stained. If these stains are difficult to remove,
use special products available on the market. After cleaning,
it is advisable to rinse thoroughly and dry.
• The inside of the oven should preferably be cleaned
immediately after use, when it is still warm, with hot water and
soap; The soap should be rinsed away and the interior dried
thoroughly. Avoid using abrasive detergents (for example
cleaning powders, etc.) and abrasive sponges for dishes or acids
(such as lime scale remover) as these could damage the enamel.
If the grease spots and dirt are particularly tough to remove, use
a special product for oven cleaning, following the instructions
provided on the packet. Never use a steam cleaner for cleaning
inside of oven.
• If you use your oven for an extended period of time,
condensation may form. Dry it using a soft cloth.
• There is a rubber seal surrounding the oven opening which
guarantees its perfect functioning. Check the condition of
this seal on a regular basis. If necessary, clean it and avoid
using abrasive products or objects to do so. Should it become
damaged, please contacts you’re nearest After-sales Service
Center. We recommend you avoid using the oven until it has
been repaired.
• Never line the oven bottom with aluminum foil, as the
consequent accumulation of heat could compromise the
cooking and even damage the enamel.
• Clean the glass door using non-abrasive products or sponges
and dry it with a soft cloth.
Bulb Replacement
To replace your oven cavity’s lamp bulb, follow this guide:
• Disconnect power from the mains outlet or switch off the circuit
breaker of the unit’s mains outlet.
• Unscrew the glass lamp cover by turning it counter-clockwise
(note, it may be stiff) and replace the bulb with
a new one of the same type.
• Remove the lamp and replace with a lamp resistant to high
temperatures (300°C) with the following characteristics:
– Voltage: 220-240V
– Wattage: 25W
– Type: G9
• Replace the glass cover and reconnect the oven to the mains
power supply.
To Next Page
Loading...
