Omega ORC97G User Manual

8
Maintenance
CLEAINING THE GREASE FILTER MESH
The filter mesh is made of high-density stainless steel. Please do not use corrosive detergent on it. Keeping
this filter clean will keep the appliance running correctly. Please follow the guidelines below.
Place the mesh in 40 – 50°C clean water, add in a small amount of detergent, and soak for 2 - 3 minutes.
Wear gloves, and clean with a soft brush. Do not apply too much pressure, as the mesh is delicate and will
damage easily.
The grease filters can also be put into a dishwasher. To do so, set the temperature at around 60 degrees.
CLEANING THE RANGEHOOD
• To protect the main body from corrosion over a long period of time, the cooker hood should be
cleaned with hot water and a non-corrosive detergent every two months.
• Do not use abrasive detergent as it will damage the body.
• Keep the motor and other spare parts free from water, as this will cause damage to the appliance.
• Before cleaning, unplug the appliance.
• If fitted with active charcoal filters, the charcoal filter should not be exposed to heat.
• Do not tear open the fixed bar around the active charcoal filter.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a
similarly qualified person in order to avoid hazards.
Replacing the Lights
Warning: Before attempting to change the lights, ensure that the appliance is
switched off and unplugged from the wall socket.
• Remove the grease filter.
• Press the spring on both sides of the LED light until the light falls out (Pic. 1).
Gently pull the light wire out and disconnect the terminal (Pic. 2).
• Reverse the procedure to replace the light. Use an identical light:
o LED modules – round lamp.
o Max Wattage: 2 x 1.5W
o Voltage Range: 12V DC
o ILCOS D Code: DSR-1.5/65-S-64
• Replace the grease filter.
9
Troubleshooting
Fault Cause Solution
Light on, but motor does
not work
The fan is blocked Contact service
The capacitor is damaged Contact service
The motor jammed and bearing
damaged
Contact service
A smell coming from the motor Contact service
Light does not work;
motor does not work
Besides the above mentioned, check the following:
Light damaged Replace lights
Power cord loose Contact service
Shake of the body
The fan is damaged and causes
shaking
Contact service
The motor is not tightly mounted Contact service
The body is not tightly hung on
wall
Contact service
Insufficient suction
The distance between the body
and the gas top too long
Readjust the distance
Too much ventilation or breeze
from open doors or windows
Choose a better location and
re-assemble the machine
The machine inclines
The fixing screw not tight enough
Tighten the hanging screw
and make it horizontal
The hanging screw not tight
enough
Tighten the hanging screw
and make it horizontal

Omega ORC97G Specifications

General

Brand	Omega
Model	ORC97G
Category	Ventilation Hood
Language	English