Omeo Evolution 1.1 - Section 5: The InfoKey Controller; InfoKey Controller Buttons

OMEO EVOLUTION USER MANUAL
SECTION 5 THE INFOKEY™ CONTROLLER
39
|
Section 5: The InfoKey™ Controller
NOTICE
The Battery levels indicated on the InfoKey™
Controller display apply to the Segway
Lithium-ion Batteries only. They do not apply
to the Omeo’s Lead Acid Auxiliary Batteries.
This chapter in the Segway PT User Manual
(Pg. 39) describes how the InfoKey™ Controller
works. It includes a description of the InfoKey™
Controller and its display, buttons and icons plus
functionality.
InfoKey™ Controller
Use the InfoKey™ Controller to operate and
monitor your Omeo. The InfoKey™ Controller has
four buttons around the outer edge and a display
in the centre.
The InfoKey™ Controller must be within 5m (16 t)
in order to communicate with your Omeo.
InfoKey™ Controller Buttons
The InfoKey™ buttons allow you to select the
Omeo’s Segway Power Base and Battery functions
and scroll through various information.
WARNING
The buttons on the InfoKey™ Controller
are quite sensitive, so only a light touch is
needed. If at any time you find that a button
isn’t working, it is important not to push it any
harder. Instead we recommend that you check
the batteries in the InfoKey™ Controller and
change if required. (Refer to Replacing the
InfoKey™ Controller Battery Pg. 86.)
NOTICE
It is vitally important you become very familiar
with the InfoKey™ Controller functions,
buttons and icons. Replace in the Segway
User Manual:
• Where it references PT replace with Omeo
• Where it references Stand replace with Sit
• Where it references Step On replace with Raise
Stabilising Legs
• Where it references Step O replace with
Lower Stabilising Legs / Coming away from
• Where it references Mat replace with Seat.
Rider Detect Error: Applies to Segway. It does not
apply to the Omeo.
NOTICE
The Omeo will only accept commands from the
InfoKey™ Controller when the Stabilising Legs
are down.