OMICRON 3
Safety instructions
1 Safety instructions
This document covers general safety instructions and information on the CPC 100 and CPC 80.
► For detailed information refer to the documents listed below and the user documentation for the
corresponding accessories.
• CPC 100 User Manual
• CPC 100 Reference Manual
• CPC 80 User Manual
1.1 Operator qualifications
Working on high-voltage assets can be extremely dangerous. Only authorized personnel who are
qualified and skilled in electrical engineering and trained by OMICRON are allowed to operate the
CPC 100 and its accessories. Before starting to work, clearly establish the responsibilities.
Personnel receiving training, instructions, directions, or education on the CPC must be under constant
supervision of an experienced operator while working with the equipment. The supervising operator
must be familiar with the equipment and the regulations on site.
1.2 Safety standards and rules
1.2.1 Safety standards
Testing with the CPC must comply with the internal safety instructions and additional safety-relevant
documents.
In addition, observe the following safety standards, if applicable:
• EN 50191 (VDE 0104) "Erection and Operation of Electrical Test Equipment"
• EN 50110-1 (VDE 0105 Part 100) "Operation of Electrical Installations"
• IEEE 510 "IEEE Recommended Practices for Safety in High-Voltage and High-Power Testing"
Moreover, observe all applicable regulations for accident prevention in the country and at the site of
operation.
Before operating the CPC and its accessories, read the safety instructions in this Getting Started
carefully. Do not turn on the CPC and do not operate the CPC without understanding the safety
information in this manual. If you do not understand some safety instructions, contact OMICRON before
proceeding.
► Observe all applicable regulations for accident prevention in the country and on the site of operation.
► If you do not understand the safety rules, contact OMICRON before proceeding.
To Next Page
Loading...
Need help?
General
