Digital Sync Input: Output sample rate can be synchronized to the signal present on the
AES/EBU input or to the AES3 signal applied to the Ext. Sync connector.
External Sync Range: Accepts 32kHz to 96 kHz for synchronization of the Digital Output
signal to an external reference. Automatically accepts sample rates
between 32kHz and 96kHz.
Connector: EMI-suppressed RJ-45 female pinned according to StudioHub+ standards, Transformer
isolated, balanced, and floating according to AES3 standard.
Remote Control Methods:
External Modem or 10/100BaseTX Ethernet.
--Modem (support not yet available as of software version 2.2): User-supplied Hayes
command compatible external serial modem connected to rear-panel DB-9 male serial
port.
-- Ethernet: TCP/IP control via web page interface and Java (TM) remote control
program included in the web pages. All software is served from the built-in web server;
there is nothing to install on the user's computer.
Ports Used: The defaults are TCP Ports 4545 and 4546 (for control and metering data,
respectively).
Connectors: Modem port - EMI-suppressed DB-9 male connector.
Ethernet - Industry standard EMI-suppressed RJ-45 connector.
GPI Interface:
Connector: EMI suppressed DB-9 female connector.
Power Requirements: Voltage: 100-250 VAC, 47-63 Hz. Less than 25 VA.
Power Connector: EMI suppressed IEC male.
Detachable 3-wire power cords supplied for US and European use.
Power Supply: Internal. Overvoltage and short circuit protected. Meets EN55022, EN55011 Level B
Conducted Emissions. EN61000-4-2, -3, -4, -5, -6 level 3 immunity compliant. Full
international safety approval. CE marked.
Environmental: Operating Temperature: 32 to 122 deg. F / 0 to 50 deg. C for all operating
voltage ranges. Humidity: 0-95% RH, non-condensing.
Dimensions: 19" wide x 1.75" high x 16" deep (48.26cm wide x 13.335 cm high x 40.64 cm deep)
including connectors. Unit requires one EIA rack space for mounting.
Shipping Weight: 12 lbs. / 5.5 kg
StudioHub
is a registered trademark of Radio Systems.
Telos/Omnia Research and Development is constantly working to improve the quality of our products.
Actual specifications are subject to change or improvement without notice.
To Next Page
Loading...
Need help?
General
