Omnia ONE User Manual

73
affected by this control and is set using the master Analog Level control previously
described.
AES Level (AES/EBU Level)
Adjusts the master audio Output level for the AES Digital Output which appears on the
rear panel RJ-45 StudioHUB connector.
Right Trim
Allows a +/-3dB adjustment of the right digital audio channel gain to correct minor
left/right balance problems in equipment following the Omnia.ONE. The left channel
output gain is not affected by this control and is set using the master AES Level control
previously described.
Samp. Rate (Sample Rate)
Configures the Output Sample Rate. Options are as follows:
[48k]
Slaves the output sample rate to the Omnia’s internal 48kHz sample clock. To
use output sample rates other than 48 kHz, Input or External sync must be used.
[Input]
Slaves the output sample rate to the sample rate present on the Omnia’s AES
digital input. Synchronization is possible over a range of sample rates from
32kHz to 96kHz.
[Ext] (External)
Slaves the output sample rate to the sample rate present on the Omnia’s AES
SYNC input. Synchronization is possible over a range of sample rates from
32Hz to 96kHz.
LW Level (Livewire Level)
Adjusts the master audio Output level for the Livewire output which appears on the rear
panel Ethernet / Livewire RJ-45 connector. This control adjusts both the left and right
stereo channels simultaneously.
Right Trim
Allows a +/-3dB adjustment of the right Livewire audio channel gain to correct minor
left/right balance problems in equipment following the Omnia.ONE. The left channel
output gain is not affected by this control and is set using the master LW Level control
previously described.
AM Options (AM Style Only)
<-Exit
Click on this option to return to the Output submenu.
Polarity Controls
These controls adjust the polarity for each of the 2 analog outputs separately.
The “A” output refers to the Left channel output and the “B” output refers to the
Right channel output. These are handy to use instead of swapping pins 2 & 3 on
XLR connectors or if the wiring is inaccessible.
There are two available settings for each polarity control: “Normal” and “Invert”
[ANA A Pol] (Analog Output Polarity for the Left Channel)
[ANA B Pol] (Analog Output Polarity for the Right Channel)

Omnia ONE Specifications

General

Brand	Omnia
Model	ONE
Category	Computer Hardware
Language	English