1. ALWAYS switch the wall outlet socket off. If
you do not switch the outlet off there is a risk
that you may touch a live pin when plugging
the Wall Power Supply into the outlet.
2. PLUG the wall power supply into the wall
outlet socket.
3. PLUG the wall power supply connector into the
Omnilux new-U.
4. SWITCH the wall outlet socket on.
5. OPERATE the selector switch on the front of the
Omnilux new-U to turn on the red LEDs, place
the transparent lens of the Omnilux new-U in
contact with treatment area or at a maximum of
1cm/0.5” from your upper forearm and leave
in position for 20 minutes. You should NOT
experience any adverse reaction during the
next 24 hours. An adverse reaction is any pain
or discomfort in the treatment area or any skin
redness that lasts for longer than 24 hours.
PAGE 10
If after 24 hours you have not experienced an
adverse reaction to the red light, repeat the
test on the other forearm BUT this time using
the infrared light. If after 24 hours you have not
experienced an adverse reaction to the infrared
light it is safe for you to use the Omnilux new-U.
To Next Page
Loading...
