What to expect
After each session you may notice a slight
reddening of the skin (mild erythema) over the
treated area. This is normal and should fade within
an hour or two.
The best results will be seen between 3 – 7 weeks
after you have completed the recommended
course of treatments. The light stimulates natural
processes that continue after the treatment
has stopped.
Before (left) and after (right) the recommended
course of treatments clearly demonstrating a
reduction in periorbital wrinkles.
How to use the Omnilux new-U
Before a treatment session ALWAYS wash the skin
with a suitable skin cleanser to remove all product
residues, pollutants, and any traces of make-up.
This will make sure that all the light from the
Omnilux new-U reaches the skin.
1. ALWAYS switch the wall outlet socket off. If you
do not switch the outlet off there is a risk that
you may touch a live pin when plugging the
Wall Power Supply into the outlet.
2. PLUG the wall power supply into the wall
outlet socket.
3. PLUG the wall power supply connector into
the Omnilux new-U.
4. SWITCH the wall outlet socket on.
5. FIT patient goggles.
6. OPERATE the selector switch on the front of
the Omnilux new-U to turn on the correct color
LEDs for the treatment session. (See ‘Treatment
Recommendations’).
7. PLACE the transparent lens of the Omnilux
new-U in contact with treatment area or at a
maximum of 1cm/0.5” from the treatment area.
(See photo on page 13).
8. REMOVE the Omnilux new-U from the affected
area after the correct treatment time.
(See ‘Treatment Recommendations’).
9. MOVE the selector switch to the center
OFF position.
PAGE 12
To Next Page
Loading...
