Omron BP6100 - Setting Date and Time on Monitor

16
2.2 Setting the Date and Time
Note
• Set your monitor to the correct date and time before taking a measurement for the
first time.
• As soon as batteries are correctly installed, the year flashes on the display of your
monitor.
1. Press the or button once to adjust the year.
Press and hold the button to quickly advance the years.
Press and hold the button to quickly go backwards through the years.
2. Press the [START/STOP] button to confirm the year and the month
will flash. Repeat the same steps to adjust the month, day, hour, and
minute.
3. Press the [START/STOP] button to store the setting.
It automatically turns off after 3 seconds.
Note
• If you need to reset the date and time, replace batteries or press and hold the
button until the year flashes, and set the date and time as above steps.
Year
Month
Day
Hour
Minute