Omron BP742 - ERROR INDICATORS

25
ERROR INDICATORS
SYMBOL CAUSE CORRECTION
Monitor could not
detect pulse wave.
Take another measurement and
remain still until the measurement
is complete.
Cuffunder-inated.
Cuff not applied
correctly.
Remove the arm cuff.
Read“TakingaMeasurement”.
Wait 2-3 minutes.
Take another measurement.
Cuffover-inated.
Device error. Contact Customer Service.
Movement during
measurement.
Keep still and take another
measurement.
Irregular or weak
pulses are detected.
Remove the arm cuff. Wait 2-3
minutes and then take another
measurement. Repeat the steps in
section“ApplyingtheArmCuff.”
If this error continues to appear,
contact your doctor.
Batteries are
exhausted.
Replace the four batteries.
Referto“BatteryInstallation.”