7
Serial Communications Connection Procedure
7.3.5. Transferring the Project Data
Transfer the project data to PLC.
Select Programs in the project
workspace of CX-programmer.
Select Transfer - To PLC from
the PLC Menu.
Select Program(s), Comments,
and Program index.
Click OK.
*The I/O table and Special Unit
Setup are unnecessary to
transfer here, because they are
already set in 7.3.3. Creating
the I/O Table and 7.3.4.
Parameter Settings.
*The Comments and the
Program index Check Boxes
may not be displayed
depending on the device type.
In such a case, select
Program(s) only and transfer
the project data.
The confirmation dialog box on
the right is displayed.
Confirm that there is no
problem, and click Yes.
To Next Page
Loading...
Need help?
General
